Molex high current 3 layer boards

Electric Motors and Controllers
Post Reply
billvon   1 GW

1 GW
Posts: 3051
Joined: Sep 16 2007 9:53pm
Location: san diego

Molex high current 3 layer boards

Post by billvon » Oct 29 2019 6:59pm

Just talked to Molex about a process they have for making 3 layer boards. The center layer is stamped copper, so can be as thick as you want. (Could be .1" copper if you wanted that thick a materials.) The top and bottom layer are more conventional plated copper. This seems like it would be great for motor inverters; drain and source go to copper bars, and everything else is a plated trace.

Paper on this:
(932.45 KiB) Downloaded 57 times
--bill von

Post Reply