Search found 6 matches

by Swell6
Feb 24 2020 5:13am
Forum: E-Bike Technical
Topic: KT-LCD5 PAS 12 magnet settings
Replies: 11
Views: 609

Re: KT-LCD5 PAS 12 magnet settings

I was using the same sensor so the wiring was ok. I've since fitted a 10 magnet disc and that works great! The manual only lists 5, 8 and 10 magnet discs so it does seem explain why the 12 magnet disc wouldn't work. I'm using a C1 value of 0 which is for the highest "start sensitivity", which is the...
by Swell6
Feb 11 2020 10:35am
Forum: E-Bike Technical
Topic: KT-LCD5 PAS 12 magnet settings
Replies: 11
Views: 609

Re: KT-LCD5 PAS 12 magnet settings

I tried a 12 magnet regular disc and no matter what the C1 setting used it wouldn't work. I've ordered a 10 magnet disc from Aliexpress so will update when that's been tested. Currently I have to turn the pedals more than one full turn before PAS kicks in, so I'm hoping that with more magnets that w...
by Swell6
Feb 11 2020 5:41am
Forum: E-Bike Technical
Topic: KT-LCD5 PAS 12 magnet settings
Replies: 11
Views: 609

Re: KT-LCD5 PAS 12 magnet settings

I have the Shimano style end cap so it would fit into that but not enough space between that and the crank. Will do some experimentation...
by Swell6
Feb 10 2020 4:07pm
Forum: E-Bike Technical
Topic: KT-LCD5 PAS 12 magnet settings
Replies: 11
Views: 609

Re: KT-LCD5 PAS 12 magnet settings

Interesting, could be a good option. My bottom bracket is very standard with square section crank fitting, very tight between crank and end cap, had to grind about 1mm off the crank just to get a regular disk in. How much axle space does a KTv12 need? Out of interest, on a KTv12 does the inner part ...
by Swell6
Feb 10 2020 11:12am
Forum: E-Bike Technical
Topic: KT-LCD5 PAS 12 magnet settings
Replies: 11
Views: 609

KT-LCD5 PAS 12 magnet settings

I'm looking to fit a 12 magnet disc to work with my LCD5 display - I currently have a 5 magnet disc. The C1 settings allow selection of different numbers of magnets, as listed below. Will the 05, 06 and 07 settings only work with sensors which detect reverse also? Or will these work with a straight ...
by Swell6
Jan 28 2020 11:25am
Forum: Motor Technology
Topic: KT36SVPR-LCD Controller
Replies: 3
Views: 841

Re: KT36SVPR-LCD Controller

I have the same issue - I've just bought a similar setup with the same KT36SVPR-LCD controller - 250W 36V. I'm not sure of the motor manufacturer. I'm also using lead acid batteries, but have ordered a Li ion battery from Aliexpress which is a fraction of the weight. It works fine when lifting the w...