Search found 5 matches

by NoClassic
Oct 24 2019 11:16am
Forum: Items for Sale - Used
Topic: Bafang SW102 Display & 48v 18A Controller
Replies: 0
Views: 1564

Bafang SW102 Display & 48v 18A Controller

I wanted to clean up the bike a bit so switched to a controller that mounts within my battery housing. The SW102 display is not compatible with the new controller so no use for it any longer either. These are near new with only a couple hours of use on them. The controller was included in one of the...
by NoClassic
Oct 22 2019 2:40pm
Forum: Motor Technology
Topic: Bafang SW102 Bluetooth LCD - OpenSource firmware and mobile app
Replies: 421
Views: 54069

Re: Bafang SW102 Bluetooth LCD - OpenSource firmware and mobile app

I currently have an SW102 display within an existing system and was hoping there was a way to get it functioning with a new KT controller upgrade that I recently purchased. Is this something that is possible given the open firmware available?
by NoClassic
Aug 28 2019 5:51pm
Forum: E-Bike Technical
Topic: Grin Base/PhaseRunner without Cycle Analyst
Replies: 13
Views: 1795

Re: Grin Base/PhaseRunner without Cycle Analyst

Thanks so much for the additional information here and within the ebike subreddit NCC1941.

Are you aware of any other controllers that would allow a more minimal installation while still offering FOC and torque sensor based pedal assist?
by NoClassic
Aug 28 2019 2:24pm
Forum: E-Bike Technical
Topic: Grin Base/PhaseRunner without Cycle Analyst
Replies: 13
Views: 1795

Re: Grin Base/PhaseRunner without Cycle Analyst

Is the output of Sempu BB correct for that controller input?
by NoClassic
Aug 28 2019 10:45am
Forum: E-Bike Technical
Topic: Grin Base/PhaseRunner without Cycle Analyst
Replies: 13
Views: 1795

Grin Base/PhaseRunner without Cycle Analyst

Is it possible to run a pedal assist only configuration utilizing the Sempu BB without the CA? I am wanting a very discreet setup because of theft concerns and given the use of the bike would not have much need for active monitoring after initial setup in the Grin controller software. If this is not...